Below is a list of all possible config file options that are interpreted/used by the xrm.py code.  The filename is ".config" and it must be located in "${HOME}/build/uh-svn-repo/trunk/software/b2l/scripts_dev/"

For svn checkouts where (re)parsing & (re)plotting data is going to be the only valid operation, be sure to set fake_it="yes" and xrm_mode="parse" among other things (see below).  Please note that the config file parser can't handle spaces between the variable name and the equals sign (also between the equals sign and the value or beginning quote (for strings), so xrm_mode = "parse" won't work but xrm_mode="parse" will.

mode="eth"
local_IP=""
fake_it="yes"
remote_IP="192.168.10.16"
remote_port="8192"
ethernet_device="blah"

# for threshScan1boardstack.py:
maximum_iterations=2000
step_initial_when_reading_from_file=1
step_initial_when_from_seed_value=1
number_of_channels_to_get_before_quitting_threshold_scan=64

# for xrm.py:
xrm_run_continuous=0
plot_continuous=1
show_plot=0
datafilesize=20000000
be_verbose_when_collecting_data=0
use_pedestal_subtraction_mode=1
retake_pedestals_at_every_filechange=0
desired_pause_between_acquisitions=0
should_cycle_slowly_through_bunch_markers=0
desired_RF_bucket=4270
RF_bucket_sample_offset=0
multicast_cal_signal=1
enable_cal_signal=0
should_plot_beam_current=1

sweep_start_bucket=4
#sweep_start_bucket=772 # 64 windows
#sweep_start_bucket=2308

#sweep_end_bucket=772 # 64 windows
#sweep_end_bucket=1540 # 128 windows
#sweep_end_bucket=2308 # 192 windows
#sweep_end_bucket=3076 # 256 windows
#sweep_end_bucket=3844 # 320 windows
#sweep_end_bucket=4612 # 384 windows
sweep_end_bucket=5116 # 426 windows

#xrm_mode="sweep"
#xrm_mode="acquire"
xrm_mode="parse"